Please Help Support by Donating

  • 2018-04-22, 01:36:42
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search


Looking for VTMR Modding Tutorials? Check out the Open Nod Development section of

Author Topic: Path Points  (Read 1709 times)


  • Member
  • *
  • Karma: 0
  • Offline Offline
  • Posts: 49
Path Points
« on: 2007-07-23, 14:03:43 »


I have make a switch and now I want to know how to make it move(to show that the switch is activated),there is a way of doing this?


Well, you can make any template_brush move, by linking a path_point to it.

With your templatebrush selected press SHFT+K, this will make a path_point for that particular brush.

If you want the object to move down, move the path_point below the brush.

If you want it to move up, move the path_point above the brush...and so on.

Now, about the switch, treat it just like a door's pathpoint. Try putting the pathpoint's YAW at 45. The pathpoint should be placed at the "pivot" of the switch.

« Last Edit: 2007-07-23, 14:20:48 by Nagaraja »

Page created in 0.087 seconds with 24 queries.