Please Help Support E-Mods.net by Donating

e-mods.net

  • 2017-09-20, 21:55:44
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search

News:

Looking for VTMR Modding Tutorials? Check out the Open Nod Development section of e-mods.net.

Author Topic: Walking through a table  (Read 989 times)

GreenDragon

  • Member
  • *
  • Karma: 2
  • Offline Offline
  • Posts: 52
Walking through a table
« on: 2013-06-05, 10:43:01 »

I've created a table by using brushes. A regular rectangle as the top and four other brushes as legs. The problem is that I can walk right through it. They are not set to walkable. Should I use any other brush setting or is something else wrong? The tabletop is 1 cell high at grid size 8.
Logged

Javokis

  • Horses Dick
  • Member
  • *****
  • Karma: 21
  • Offline Offline
  • Posts: 2362
    • E-Mods.net
Re: Walking through a table
« Reply #1 on: 2013-06-05, 10:47:43 »

Make sure it's fully connected to the floor... it might be floating a bit above a walkable floor. Try cutting the floor beneath it too and make that section "non-walkable."
Logged
"There's nothing wrong with horses dicks, there's nothing wrong with sucking horses dicks." -Signo
 

Page created in 0.055 seconds with 19 queries.